Fire Panel Operation Guide
1. The panel shown can be found within the warehouse, in the utility room.
2. The LCD screed by default will display the message below. When an alarm is tripped , the affected stations can be seen on the screen.
3. To access the panel, insert the panel key found above the station.
4. After opening the panel, the interface will be shown below
5. When an alarm is tripped at a station, locate the two buttons: Silence Alarm, & Reset.
6. In order to resolve the alarm, first ensure that the affected station is safe and is free of hazards.
7. Once the station is safe and resecured, call the fire alarm vendor and report the incident
8. If authorized by vendor, the user can reset the station by first pressing the Alarm Silence button, then holding the RESET button for 5 seconds.
Tip: Tip! It is important to know the current zones that correlate with the fire panel once a user is shown a station's location.
Zone 1 - warehouse
Zone 2 - maintenance bay
9. The annunciator is an extension of the base panel, commonly used by emergency services if the base panel is unavailable. The annunciator has the same core functions and buttons as the base panel, with the exception of the keypads.
10. One type of station are smoke detectors.
11. Another station type are pull stations. Once triggered, a message will appear in the highlighted section. To reset the alarm, the station must be opened, and a tab must be pulled to reset the station.
